Draw Cross-Band Lines and Boxes
- 2 minutes to read
This document explains the basics of using cross-band controls and describes their main features.
The following two cross-band controls are available.
- XRCrossBandLine allows for the drawing of vertical lines, which are not restricted to a particular band. For example, it can be used to emphasize a report section consisting of multiple band areas.
- XRCrossBandBox allows for the drawing of rectangles through several bands. It can be used to encompass a report section consisting of multiple band areas.
To add a cross-band control to the report, drag the appropriate control from the toolbox DX.20.1: Report Controls tab and drop it onto the report's area.
At runtime, to specify the bands at which a cross-band control starts and ends its drawing, use the following properties.
- XRCrossBandControl.StartBand - determines the band from which a cross-band control starts its drawing.
- XRCrossBandControl.EndBand - determines the band where a cross-band control finishes its drawing.
And to specify the control's coordinates (measured in report units) within these bands, use the following properties.
- XRCrossBandControl.StartPointF - determines the starting point where the cross-band controls starts to draw.
- XRCrossBandControl.EndPointF - determines the end point where the cross-band controls stops to draw.
- We recommend that you start and end cross-band controls on paired bands (Report Header/Footer, Page Header/Footer or Top/Bottom Margin). Otherwise, these controls can be incorrectly drawn in the report document.
- Cross-band controls cannot start/end on a vertical band.
If a cross-band control's lines are less than 0.5 pixels thick, such control is not included in export files that have the following formats: